|
Remember to check your local laws and be aware of compliance issues when making alterations to your firearms. ________________ | |
|
Orders placed between October 14th -19th, will not ship until the 20th or 21st.
MilSurpStuff.com uses
to ship to
US addresses
ONLY (no international shipping)
__________________ | |
|
If an item that shows "Out of Stock" email me and I'll try to give you an estimate of when it will be back. |
|
ASSEMBLY OF NON-SPORTING SHOTGUNS AND SEMIAUTOMATIC RIFLES FROM IMPORTED PARTS Disclaimer: This is an attempt to interpret this law. Information taken from this context should not be considered permission to manufacture semiautomatic rifles. (a) No person
shall assemble a semiautomatic rifle or any shotgun using more than
10 of the imported parts listed in paragraph (c) of this section if
the assembled firearm is prohibited from importation under section
925(d)(3) as not being particularly suitable for or readily
adaptable to sporting purposes. (1) The assembly of such rifle or shotgun for sale or distribution by a licensed manufacturer to the United States or any department or agency thereof or to any State or any department, agency, or political subdivision thereof; or (2) The assembly of such rifle or shotgun for the purposes of testing or experimentation authorized by the Director under the provisions of Sec. 178.151; or (3) The repair of any rifle or shotgun which had been imported into or assembled in the United States prior to November 30, 1990, or the replacement of any part of such firearm. (c) For purposes of this section, the term imported parts are: (1) Frames,
receivers, receiver castings, forgings or stampings [T.D. ATF-346, 58 FR 40589, July 29, 1993] EFFECT ON
STATE LAW U.S. Department
of Justice
As mentioned above, the below chart shows which regulated parts are contained in each rifle.
|
|
from TAPCO.com |
|
|
